Jun 15

Config file share

3 comments

Hi can anyone with the XXL share their config file please, thanks in advance :)

Jun 15

There is a copy of the XXL settings at the bottom of the instructions :)

Lol it proves that we should read the instructions thoroughly before making a fool of ourselves :)

 

I presume with your instructions below that I wouldn't know until I jogged

which setting I would need ?

 

For ¼ micros steps you will be - $102=160

For 1/8 micros steps you will be - $102=320

 

 

 

New Posts
  • I'm finally going thru the install of my install of the Shapeko 3 XXL with the HDZ and the limit switches I bought. I cant find a clear picture of anyones else's setup of the back of the machine . I want to see how the wire is run for the 3 limit switches. I cant seem to get a full sized pic on the internet at all. Also , how did everyone run the wire from the switches....I'm assuming thru the plastic chain harness ? not sure
  • I would like a recommendation on a good quality & powerful enough laser attachment. I'm currently running a water-cooled 80mm 2.2KW spindle using Mr. Beaver's HDZ. Sincerely appreciate your recommendation .
  • I returned the 110Volts Spindle Kit & got this replacement yesterday. https://www.amazon.com/gp/product/B01MXLXRTY/ref=ppx_yo_dt_b_asin_image_o00_s00?ie=UTF8&psc=1 I’m having fun installing it as we speak. I’m running a 100ft wire from my dryer’s 220 volts outlet in my basement to my workroom. Cannot wait to have it up & running. I’m using a closed cooling loop which has an Alphacool NexXxoS XT45 Full Copper 560mm radiator, cooled by 4x140mm FANS.