Ken Chalk
Apr 1

GRBL settings for 80cm x 80cm Beaver Pro

4 comments

Anyone open to sharing your GBRL settings.

Mr Beaver
Apr 1

I'll post mine when I get back tomorrow 😊

1
Ken Chalk
Sep 28Edited: Sep 28

 

not spring after using your GBRL settings

 

 

 

0
Ken Chalk
Apr 5

Are these CNC XPro settings correct? I’m having an issue where the left side of my ex access is not keeping pace with the right

 

 

 

1
New Posts
  • Ken Chalk
    Jul 29

    Question about Leadshine DCM86OH

    Will this setup work my beaver pro? 60volt 10amp 600watt swishing power supply https://www.amazon.com/Supply（SMPS）-220VAC-DC60V-Transformer-Monitoring-Industrial/dp/B079D9KTF7 Lead Shine DM860H Stepper Driver https://www.ebay.com/itm/DMA860H-For-Leadshine-7-2A-Stepper-Motor-Driver-DC24-80V-CNC-Stepping-Motor/372500493549?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
  • fredthenuke
    Aug 10

    Where Does One Find a Pro Beaver?

    Is the Beaver Pro replaced by the HDZ Frame Kit? I've not yet located where to view/purchase the Pro frame for a comparison to the HDZ Frame kit.
  • Jaysen Moore
    Apr 22

    Need Help with CNCJS on pi3

    I am having trouble getting cncjs going on the pi3. it seems that it is running but i am not able to connect via webbrowser. Connection blocked. The install directions for pi3 online are very outdated. I believe the problem may be with opening the port on ipchains. If anyone could help it would be greatly appreciated.